Jinhu Henghai Precision Machinery Co., Ltd

Jinhu Henghai Precision Machinery Co., Ltd

Contact us
 
News information

Installation instructions of glue gun

Release time:2019/11/28 0:47:56    Click through rate:730   

    The glue gun has been tested before leaving the factory and can be installed and used immediately. Each glue gun has a solenoid valve to control the air supply. Because the switch speed of glue gun is extremely fast, the installation of the solenoid valve should be as close to the glue gun as possible and keep the same distance. Henghai can provide the solenoid valve and the corresponding filter type pressure regulating valve.

    The solenoid valve can be controlled by the rubber machine controller compensator or rubber machine high-speed or travel switch, and the contact and electric eye shall be installed in the adjustable position.

    ①. The glue gun can be installed at the required position of the host machine. The size of the glue gun body mounting frame is 16mm diameter mounting hole, which is fastened with M6 bolts. The body of the glue gun has the function of filtering device and fine adjustment of glue spraying amount. The observation hole in the middle of the nozzle can check whether the working condition and sealing of the nozzle are good. Generally, the nozzle and object surface should not exceed 60mm.

    ② connection between spray gun and throat: connect spray gun to throat with two sets of spanners (90 °, 45 °, 180 ° joint can be used)

    ③ connect the gun electrical connector to the throat electrical connector.

    ④ connect the four-way solenoid valve with the electrical circuit of the spray gun. When the spray gun is required to be closed, the compressed air flows from the solenoid valve to port B. when the solenoid valve acts and the compressed air flows to port a, the spray gun opens, and the air pressure is 5-8KG / cm2.

    ⑤. The temperature of the spray gun can be read out through the temperature of the host machine, and the temperature of the spray gun surface can be measured with a thermometer.

    ⑥. Remove the air and protective oil from the spray gun, heat the spray gun, screw off the spray gun nozzle, lower the container, add a proper amount of hot melt adhesive to the melting bar, start the power supply of the hot melt adhesive machine, when the temperature reaches the normal working temperature, manually start the gear pump, manually open the solenoid valve, discharge the air and oil in the gun until all the hot melt adhesive is ejected.

    ⑦. Install the nozzle. Try hot-melt adhesive and check whether it is in good condition.

Front:Application scope of hot melt glue machine
Next:Professional hot melt glue machine
 
Home          About us           Product           Case          News          Download          Honor           Contactus
All rights reserved by Jinhu Henghai Precision Machinery Co., Ltd    Address: Daxing Industrial Zone, Jinhu, Jiangsu
Manager: Mr. Ye Tel:18652339870      Technical support: Mr. Hu Tel:18262709789